#1034463 - 09/29/06 11:20 AM
MadMax gets dynoed
|
PowerSurge
Climber
Registered: 09/11/06
Posts: 510
Loc: Just North of Daytona, FL
|
Had some free time between dyno appointments yesterday, so since I recently finished the exhaust on MadMax, I figured I'd throw it on the rollers and give him a tune.
Pretty much made what I expected. I was figuring about 530-550rwhp on a street tune, and it made just about 540/585. Keep in mind that even though it's a built motor, it's stock heads, stock TB, and stock cast exhaust manifolds. Not that it matters, you can't even give the car 1/4 throttle without it killing the tires.
This is a 93 octane pump gas tune, 16 degrees total timing. It would pick up another 30hp or so with some 100 octane and a race tune.
And a pic on the dyno...
_________________________
Sal Mennella - Power Surge Performance - Custom Tuning Specialists 2000 CVPI Project MadMax 2006 - 5.4 Whipple powered 600rwhp 11.39 @ 121 - Sold but not forgotten 2003 CVPI - current daily driver 1990 Turbo SHO - for sale CSX 4241 Shelby American 427 Cobra S/C 
|
|
Top
|
|
|
|
|
#1034464 - 09/29/06 11:44 AM
Re: MadMax gets dynoed
|
98VicP71
223 RWHP/ 257 RWTQ
Poobah
Registered: 03/28/06
Posts: 9068
Loc: ATL
|
That thing is Sick!!!!!! Wish I could do that. What year CV did you use? Was there major mod's involved or was it pretty much like any onther engine swap?
_________________________
"Today is the tomorrow that you worried about yesterday!" 01 CVPI, (Count Blackula)155k mi, 3:73w/T-Lok w/Carbon Clutch upgrade, Typhoon intake, BBK 75MM TB, ADTR P&P plenum, Steeda 1/4" Spacer, HiTech Stage II Cams, MZT w/Dyno Tune 93, 22c plugs, 180* T-Stat, TRE 255LPH Fuel Pump, Custom 2.5" Madrel exhuast w/single spun cats, Magnaflow mufflers, Blacked out rear, JMOD, Steeda Underdrives, Scanguage II, Custom Gauges, and 35% tint all around. (11/07/09) 14.88@90.036MPH 4180#'s R/T .032
|
|
Top
|
|
|
|
|
#1034465 - 09/29/06 12:20 PM
Re: MadMax gets dynoed
|
Quickvic30
Vic N/A king & n2o king ;)
Poobah
Registered: 02/24/05
Posts: 8899
Loc: out fishin in the stix in MN
|
I've been waiting to see this. any video of the pulls?
|
|
Top
|
|
|
|
|
#1034466 - 09/29/06 01:07 PM
Re: MadMax gets dynoed
|
JeffBoudah
Poobah
Registered: 06/05/03
Posts: 5143
Loc: Holland,MI
|
NEED MORE PICS! i want to see this thing with the hood closed!
_________________________
1985 Crown Victoria 2-door  2003 Explorer XLT 81k miles, bone stock and staying that way... maybe 1990 Grand Marquis LS, In the junk yard, RIP!
|
|
Top
|
|
|
|
|
#1034467 - 09/29/06 01:36 PM
Re: MadMax gets dynoed
|
98VicP71
223 RWHP/ 257 RWTQ
Poobah
Registered: 03/28/06
Posts: 9068
Loc: ATL
|
if you want to see it with the hood closed.
http://www.crownvic.net/ubbthreads/showflat.php?Cat=&Board=UBB1&Number=1262488&page=&view=&sb=5&o=&fpart=1&vc=1
There are pics of it in this thread.
_________________________
"Today is the tomorrow that you worried about yesterday!" 01 CVPI, (Count Blackula)155k mi, 3:73w/T-Lok w/Carbon Clutch upgrade, Typhoon intake, BBK 75MM TB, ADTR P&P plenum, Steeda 1/4" Spacer, HiTech Stage II Cams, MZT w/Dyno Tune 93, 22c plugs, 180* T-Stat, TRE 255LPH Fuel Pump, Custom 2.5" Madrel exhuast w/single spun cats, Magnaflow mufflers, Blacked out rear, JMOD, Steeda Underdrives, Scanguage II, Custom Gauges, and 35% tint all around. (11/07/09) 14.88@90.036MPH 4180#'s R/T .032
|
|
Top
|
|
|
|
|
#1034473 - 09/30/06 12:28 AM
Re: MadMax gets dynoed
|
Geoff_93Vic
Over the Hill
Registered: 10/10/00
Posts: 3189
Loc: Atlanta, GA USA
|
that is completely bad-azzzz !!! almost 600 ft/lbs is crazy good. 
_________________________
Geoff in the ATL.
• 1998 P74 with SCT XCalibrator 2 tuning by FPS, Brembo rotors, ceramic pads, Kumho 235/60/16 716s, Dorman intake.
• 1993 P73 aka "Bernie" with some mods: » 1998+ rotors [12.4"], calipers, hoses, end links, lower ball joints & tie-rod ends. » SVO headers, Catco converters, X-pipe, Magnaflow SS mufflers, FRPP 3.73s, Traction-Lok. » AMMX driveshaft, extended tailshaft housing and slip yoke. » 77mm pro-m meter, heat shield & CAI tube, 70mm frpp t-body, pulleys. » TransGO kit, B&M tranny cooler, Black Magic e-fan, Aluminum rad. » 16x7 steel rims, 235/60/16 Kuhmo KH11s, Tokico gas shocks, NN¦EE PI springs. » Runs low 15s, need to run a new 1/4 mile and dyno pull. » 11.25" Mark 8 converter & 6-bolt flexplate. » SCT tuning / chip from FPS.
|
|
Top
|
|
|
|
|
#1034474 - 09/30/06 12:39 AM
Re: MadMax gets dynoed
|
theredlineboss
Over the Hill
Registered: 08/10/04
Posts: 1528
Loc: Taylor, MI
|
Sweet!
_________________________
1996 Police Interceptor-Being replaced by a '97 CV **192K miles**Engine: '03 4.6 w/ underdrives, shorties, custom downpipes, MZT, 70MM T/B, ADTR ported plenum, & Dyno Tuned. Trans: Y2K 4r70w w/ J-mod, Spiral Lock clip, '04 Marauder TC, and an Econoline trans cooler. Suspension/steering/brakes: '02 PI steering box, 17" 'stang wheels, '95 ABS master cyl., ADDCO bars, and Big Brake Upgrade! Misc: '98+ Heated mirrors, 2-tone Gray interior, 98+ gauges, oil cooler-delete, and LX Sport console w/ floor shift!
|
|
Top
|
|
|
|
Moderator: JohnG, dRock96Marquis, Liquid
|
The Tire Decision Guide
|
|
|
